TARGET BUSY
TARGET BUSY
If the message “TARGET BUSY” is displayed on the monitor, the target is busy because of calibration. Calibration takes place automatically after each shot and takes a fraction of a second. Therefore, this message does normally not appear on the monitor.
If the message “TARGET BUSY” appears on the monitor, the target must be checked!
Check the condition of the target maintenance. In addition, check whether light is shining directly on the measuring system inside the target. Do not use lighting with “warm” light, such as incandescent bulbs or halogen light. LED or fluorescent tubes are to be preferred.
Information on maintenance and lighting can be found in the manual “Installation, Start-up, Maintenance” of the target.
Helpful information can also be found here in the Knowledge Base under the menu item “Targets“.